Aquaplug waterproofing compound

AQUAPLUG is a cement-based, rapid-setting hydraulic compound. It stops running water, seals leaks/seepages through concrete or masonry walls and floors. It is a ready-mixed dry powder compound, which only requires the addition of clean water.

PROPERTIES:

• Rapid setting: Sets, expands and bonds tenaciously to seal off active water in less than 2 minutes
• Contains no metal particles
• Will not rust, shrink, oxidized nor deteriorate
• Repairs permanently when properly applied

USES:

• Instantly stops flowing/pouring/running water under pressure.
• Plugs holes, cracks, faults causing leakages and seepages through concrete floors, walls & junction and general masonry.
• Seals to prevent seepages around inserts such as pipes and sleeves and other metal fixtures in masonry and concrete.
• Similar applications in any architectural or structural concrete and masonry, mines, sewers, tanks, tunnels reservoirs, pits etc.

SURFACE PREPARATION:
Spot of area to be plugged must be free of any dirt, cuttings, loose concrete or any foreign matter. Use wire brush or any suitable tool. If less than 19mm in width and depth, chisel to this measurement with opening at surface to be narrower than the bottom for best results. If hole or crack is not leaking at time of repair, soak area before plugging with AQUAPLUG.

MIXING:
Mix AQUAPLUG with clean potable water only. Do not use saline water. Mix 3 parts of AQUAPLUG with 1 part of water to form a plastic mass approximately the same shape as the hole or crack to be plugged. Hardening takes place 1 minute after addition of water, so AQUAPLUG must be mixed and applied quickly.
CAUTION: AQUAPLUG that is already hardening, must not be made workable by re-stirring or re-mixing.

SAFETY:

Avoid splashing into eyes or contact with skin. In case of such contact, flush eyes thoroughly with water and seek medical advice. Wash hand thoroughly after handling and before smoking or eating. Do not take internally. Generates heat when mixed with water. Wear gloves when handling.
CAUTION: AQUAPLUG could be injurious to your eyes. It could also cause skin irritation.

STORAGE:
When store in a cool dry place AQUAPLUG will remain usable for a period of 1 year from date of manufacture.

PACKAGING:
1.25kg steel can
5kg steel can
25kg plastic container (special request)

COVERAGE:
1kg of AQUAPLUG approximately fills a volume of H10cm x W 2.5cm x D 2.5cm (dependent on temperature, workmanship and site conditions).